System Design Engineer
Thermo Fisher Scientific, Inc.
Brno, Czech Republic
před 2 dny

General Deliverables :

  • Knowledge of methods, techniques and processes with emphasis on practical, applied knowledge using known policies, methods and practices.
  • Owner of a module, specifies own tasks.
  • Results are monitored by manager, failure to achieve objectives will cause delays in schedules.
  • Builds productive internal / external working relationships.
  • Works on diverse objectives & problems of a moderate scope where analysis of situations or data requires a review of a variety of factors.
  • Interactions are with peers & networking with senior internal and external personnel in own area of expertise. Responsible to meet objectives based on policies & subject to managerial review.
  • Authority is to act within defined policies within the area of expertise / knowledge under management direction.
  • Applies company policies & procedures as well as good judgment and thinking to develop solutions to problems.
  • Acts as an advisor to peers & project resources to meet schedules and / or resolve technical problems.
  • Specific Deliverables :

  • Work on New Product Introduction (NPI) projects as they transition from concept through release according to PMP, MDP, MDM process.
  • The CT system engineer is responsible for completing all NPI deliverables assigned.

  • Responsible for the defining and executing (mid range) TEM optical design, test plans and methods of new and existing (mid range) TEM platforms and compile results in documents.
  • Responsible for the defining and executing (mid range) TEM vacuum design, test plans and methods of new and existing (mid range) TEM platforms and compile results in documents.
  • Active role in defining (mid range) TEM product or process improvements.
  • Active role in defining (mid range) TEM roadmap definition.
  • Defefine and execute test plans and methods of new complex hardware / software components, and compile results in document.
  • Executes development task and work packages within the PMP project.
  • Provide input during the specification and design phase of new products.
  • Communicate frequently with project leaders on progress, technical issues and suggest alternative solutions. Also frequently communicates with TSG, OE and manufacturing project members to provide them with necessary input.
  • Take responsibility for the safety around the design and designated prototype / system setups.
  • Sets up training and coordinates / trains Manufacturing, Sustaining Products and Service personnel in new product build, test, install and repair procedures.
  • May develop troubleshooting procedures

  • Supports factory and field service engineers with first builds, installs and upgrades of newly introduced systems and modules to ensure proper working order.
  • This may require travel to various customer locations worldwide to support installations and upgrades.

  • Leads cross-functional and cross-site improvement projects for products and processes. Sets goals for on-going projects.
  • Gives input for ongoing training for factory and field service engineers.
  • May execute troubleshooting in factory or field service
  • May provide input or execute engineering changes to support factory and service as needed.
  • Ensure that ECO process WIP, cycle time and other targets are being met.
  • Develops close relationships with Manufacturing, Logistics, Sourcing, NPI Engineering, TSS, PLM, Quality, R&D and Application managers to adequately resolve technical conflicts.
  • Ability to set and create right working climate.

    Přidat do oblíbených
    Odebrat z oblíbenýcch
    Můj e-mail
    Kliknutím na "Pokračovat", souhlasíte s tím, že neuvoo sbírá a zpracovává vaše osobní údaje, které jste poskytli v tomto formuláři, aby vytvořili neuvoo účet a přihlásili vás k odběru emailových upozornění v souladu s naší Ochranou Osobních Údajů . Váš souhlas můžete vzít kdekoliv zpět, následováním těchto kroků .